Spelter Sockets

Material Specification

• Sockets up to 4" are ASTM A148 steel, grade 105/85
• Sockets above 4" are ASTM A148 steel, grade 115/95
• All sockets are magnetic particle inspected at critical areas and proof tested on special order

Tolerances

• Dimensions under 4": + 1/8"
• Dimensions over 4": + 1/4"
• Q (smaller sizes): + 1/32"
• D: +0 - 1/32" in a self-colored socket

Note

Dimensions and tolerances shown are prior to galvanize

Abbr:
A T/U: A for Take-Up
E T/U: E for Take-Up
TH T/U: TH for Take-Up
Wt T/U: Wt. (lbs.) for Take-Up

Material Specification

• Sockets up to 4" are ASTM A148 steel, grade 105-85
• Sockets above 4" are ASTM A148 steel, grade 115-95
• All sockets are magnetic particle inspected at critical areas and proof tested on special order.

Tolerances

• Dimensions under 4": +  1/16"
• Dimensions over 4": +  1/8"
• Q (smaller sizes): : +  1/32"

Note:

Dimensions and tolerances shown are prior to galvanize

Material Specification

• Sockets up to 4" are ASTM A148 steel, grade 105/85
• Sockets above 4" are ASTM A148 steel, grade 115/95
• All sockets are magnetic particle inspected at critical areas and proof tested on special order

Tolerances

• Dimensions under 4": + 1/8"
• Dimensions over 4": + 1/4"
• Q (smaller sizes): + 1/32"
• D: +0 - 1/32" in a self-colored socket

Note

Dimensions and tolerances shown are prior to galvanize
Cast Sockets are available for use in extreme temperatures; these must be special ordered.

* A T/U = A for Take-Up
* E T/U = E for ...

Type 6 Anchor Sockets
This socket is used for structural strand and rope. It is provided with a rod and semi finished, heaavy hex nut for tensioning cable assemblies and making final length adjustments.

Tolerances

• Dimensions under 4": + 1/16"
• Dimensions over 4": + 1/8"
• Q (smaller sizes): + 1/32"

Note

Dimensions and tolerances shown are prior to galvanize

Type 7 Anchor Sockets Zinc-Poured
This socket is used for structural strand and rope. The anchor connection is affected through the bearing of an adjustable spanner nut. Furnished with or without internal threads (internal threads are used to accomodate tensioning jack)

Tolerances

• Dimensions under 4": + 1/16"
• Dimensions over 4": + 1/8"
• Q (smaller sizes): + 1/32"

Note

Dimensions and tolerances shown are prior to galvanize

Type 8 Anchor Sockets
Used for structural strand and rope, this is a bearing-type socket.
It is assembly length is adjusted by shimming at the bearing surface.

Tolerances

• Dimensions under 4": + 1/16"
• Dimensions over 4": + 1/8"
• Q (smaller sizes): + 1/32"

Note

Dimensions and tolerances shown are prior to galvanize